Launch Control

TunerPro launch control maps

Setting up LC:

Set the following maps in TunerPro:

Configuration Launch Control

Launch_PVS_min (i suggest to set this switch over 50% and UNDER 70%. Anything different may lead to non-working LC)
Launch_TCO_min (and this to "-48" )
Launch_RPM_max
Launch_VS_max (set to "1")

Using LC:

Make sure coolant temp is equal or above the threshold and ASC/DSC is turned off
Depress the clutch pedal
Put car into first gear
Floor the accelerator pedal! (At least that °PVS matches the threshold!)
Engine speed should bounce at chosen rpm setpoint. There may be offset which engine speed bounces, like +/- 200rpm
Release clutch pedal while holding accelerator pedal down.
Engine speed will be reduced until vehicle speed exceeds chosen threshold (currently not working!)

Engine RPM setting may be adjusted according to road conditions/tire setup, in order to minimize wheel spin.

For additional aggressiveness set "c_n_max_hys_max" to 32 or 64, then LC is much less bouncy

Example video:

Alternative for non working LC

Map reduction "fewmaps"

The _fewmaps file reduces the number of used maps to the following ones:

Injection
- Idlespeed: ip_ti_tco_1_is_ivvt__n__maf
- Part load: ip_tib__n__maf
- Full load:

VANOS
- Idle speed: IP_CAM_SP_tco_1_IN_IS / IP_CAM_SP_tco_1_EX_IS
- Part load: IP_CAM_SP_tco_1_IN_PL / IP_CAM_SP_tco_1_EX_PL
- Full load: IP_CAM_SP_tco_1_IN_FL / IP_CAM_SP_tco_1_EX_FL

This is great for finding basemaps.