Advertising:
MS4x Flasher: Difference between revisions
From MS4X Wiki
Line 10: | Line 10: | ||
Its always great to have a complete backup of the data stored in the ECUs flash memory, but you can chose between full or partial read out. | Its always great to have a complete backup of the data stored in the ECUs flash memory, but you can chose between full or partial read out. | ||
Partial | "Partial Read" only includes the 64kByte of calibration data, whereas "Full Read" contains all 512kByte of data (excluding the ISN area for sensitive data). | ||
Note: Some ECUs are read locked for DS2 reading, which is the protocal of communication MS4X Flasher uses. In this case you have to read it ion boot mode with JMGarage flasher. | |||
[[File:MS4X_Flasher_Read.png|500px|frameless]] | [[File:MS4X_Flasher_Read.png|500px|frameless]] |
Revision as of 14:00, 5 July 2021
Read From ECU
The first and default page is the ECU read function, where you can read out any MS42 or MS43.
Its always great to have a complete backup of the data stored in the ECUs flash memory, but you can chose between full or partial read out.
"Partial Read" only includes the 64kByte of calibration data, whereas "Full Read" contains all 512kByte of data (excluding the ISN area for sensitive data).
Note: Some ECUs are read locked for DS2 reading, which is the protocal of communication MS4X Flasher uses. In this case you have to read it ion boot mode with JMGarage flasher.
Write To ECU
EWS Sync
Reset Adaptation
Diagnostic Codes
DS2 Command Sender
Checksum Correction